Asphalt Driveway Cost: What You Pay For
Stoutwell Paving · September 29, 2026 · 7 min read
A new asphalt driveway typically costs $7 to $13 per square foot installed, covering minor site preparation, materials and labor. Overlays, tear-out and sealcoating each have their own range. Below, we set all four side by side, then walk through why the numbers differ and what pushes a driveway toward the low or high end.
For a figure on your own driveway, the next step is a free written quote. To understand the ranges first, read on.
The price per square foot
Asphalt work is priced by the square foot, so ranges can be compared across driveways of different sizes. Four ranges cover the jobs homeowners ask about most.
| Job | Typical price | What it covers |
|---|---|---|
| New asphalt driveway | $7 to $13 per square foot | Minor site preparation, materials and labor |
| Overlay or resurfacing | $3 to $7 per square foot | A new asphalt layer over an existing driveway |
| Removal of the old driveway | $2 to $4 per square foot | Tear-out and disposal before new paving |
| Sealcoating | $0.88 to $2.10 per square foot | A protective coat on sound asphalt |
A double-car driveway runs about 400 to 600 square feet. A single-car driveway is smaller and a long or wide one is larger. Because every range is per square foot, the size of your own driveway matters more than any single average.
Our asphalt cost per square foot page covers parking lot work. Below, we explain what sits behind the driveway ranges.
What that price includes
The $7 to $13 range is for an installed driveway, not just the material. The range covers minor land preparation, so a site that needs more grading or base work can cost more. A new driveway on bare ground moves through the same order of work each time.
- Grading. The ground is shaped so water runs off the surface and away from the house.
- Stone base. A compacted layer of crushed stone goes down under the asphalt to carry the load and move water through.
- Hot-mix asphalt. The asphalt is delivered hot and spread while it is still workable.
- Rolling. A roller compacts the mat so the surface is dense and even.
Stoutwell Paving offers this work: we grade and pave new driveways, and we pave extensions and side pads.
Thickness moves the price on its own. The deeper the asphalt, the higher the cost, because additional layers mean more material volume. A driveway that needs more depth needs more asphalt, and the per-square-foot figure climbs with it. The right thickness depends on the ground and the use the driveway will get, so it is settled on site.
Replacing an old driveway
A replacement has two parts: taking the old surface out and paving new. Removal typically costs $2 to $4 per square foot. That work covers breaking up the old surface, hauling the pieces away and disposing of them. A larger or thicker old surface means more to break up and haul.
After removal, the new driveway is priced at the $7 to $13 rate above. In practice that means a replacement adds a removal line to the new-driveway line. Our driveway tear-out and replacement page describes how that work is done.
An existing driveway that is still sound may not need to come out at all. Resurfacing lays a new layer of asphalt over the old one, and it typically costs $3 to $7 per square foot. That is lower than a new driveway because there is no tear-out and no new base. See asphalt overlay and resurfacing and how it differs from a full replacement. Whether a given driveway suits an overlay is decided on site, after looking at the surface and what is under it.
Why driveway prices differ
Price three driveways and you get three different numbers. The reasons are ordinary.
Different sizes and scopes. Driveways run from about 400 to 600 square feet for a double-car layout to much more for a long or wide one, and one price may fold removal into a replacement while another lists removal on its own line.
Different dates. Prices move, so a figure from a few years ago can sit below one from this season.
Different ground. A driveway on firm, well-drained ground needs less base and grading than one on soft or wet soil, and that work shows up in the total.
The ranges above are typical prices; your own number comes from a free written quote after we look at the driveway.
Where a driveway lands inside each range comes down to its size, the base and drainage work it needs, and how easily equipment reaches the site.
What moves the price
Within any range, a few things decide where a driveway lands. The right driveway depends on the soil and base, the drainage, local permit rules and the weather when the asphalt goes down. Requirements vary by site, scope and jurisdiction; the city or county permit office and an on-site inspection determine what applies.
Access. A narrow entry, a steep slope or a tight turn can limit which machines reach the site, and that can change the quote.
Base and drainage. The National Asphalt Pavement Association says standing water is the leading cause of driveway failure. That is why grading and the stone base matter so much, and why we look at where water goes before quoting. A driveway that needs more base work or drainage attention costs more than one that does not. The National Asphalt Pavement Association’s driveway guide lists questions worth settling before a date is booked.
Season. Late spring to early fall is the usual window for paving a driveway, and it is worth asking whether an off-season date prices lower. Weather on the day also affects whether a job goes ahead.
Job type. A new driveway, a replacement with tear-out and an overlay each draw on different lines of the rate card, so the mix of work changes the total.
Upkeep costs
A driveway has costs after the paving day, and sealcoating is the one homeowners ask about. Sealcoating typically costs $0.88 to $2.10 per square foot. We seal existing asphalt driveways as a separate job from paving.
Resealing every 2 to 5 years is the most common advice, and the right interval for one driveway follows the condition of its surface.
Lifespan is also worth weighing before you compare a driveway against its cost. A driveway that is built on a sound base and kept sealed serves longer than one left alone. How long a specific driveway serves depends on the base, the drainage, the traffic and the upkeep it gets.
Frequently Asked Questions
How much does a new asphalt driveway cost?
A new asphalt driveway typically costs $7 to $13 per square foot, covering minor site preparation, materials and labor. Your own number comes from a free written quote.
Is an overlay cheaper than a new driveway?
Yes. Resurfacing typically costs $3 to $7 per square foot, against $7 to $13 for a new driveway. An overlay skips tear-out and new base.
Does removing an old driveway add to the cost?
Yes. Removal is a separate line, typically $2 to $4 per square foot. It covers breaking up the old surface, tear-out and hauling.
Why do driveway prices vary so much?
Driveways differ in size, scope, base work and the month they are paved, and each one moves the total. That is why a free written quote for your own driveway is the number to plan around.
Get a written number for your driveway
The price you pay depends on the size of the driveway, the job type, the ground under it and the season, and a free written quote turns that into a number once we have seen the site.
For parking lot prices, visit our pricing page. To begin a quote, request a free quote and tell us what you have in mind: a new driveway, a replacement, an overlay or a sealcoat. Get your free asphalt driveway quote.
Ready for a Price on Your Property?
Guides give general ranges. Your free quote covers your own lot or driveway.
Cost Guides Asphalt Parking Lot Repair Cost: Cracks and Potholes
Our parking lot crack filling runs $0.65 to $2.25 per linear foot and patching $2 to $12 per sq ft. See what moves each rate, then request a free quote.
Cost Guides Parking Lot Sealcoating Cost Per Square Foot
Our parking lot sealcoating runs $0.15 to $0.30 per square foot. See how to estimate a church, school or business lot, then get a free written quote.
Cost Guides Parking Lot Striping Cost Per Stall and Per Foot
We restripe a parking lot for $4 to $5 per stall, and a new layout runs $0.50 to $1.20 per foot. See what moves the price, then get a free quote.
Ready for a Free Quote?
Get a free, no-obligation quote for your property.
Get Your Free QuoteOr call us directly: (919) 219-2946
Final scope, schedule, and pricing are confirmed after an on-site inspection and documented in the written project agreement.
Get a free quote for your lot
We seal, stripe and repair lots for churches, schools and shopping centers.